Hyundai Venue: Front Seat / Front Seat Assembly. Repair procedures

Hyundai Venue (QX) (2020-2025) Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Assembly. Repair procedures

Replacement

Loosen the front seat mounting bolts.

[Front]

Tightening torque :

49.0 - 63.7 N.m (5.0 - 6.5 kgf.m, 36.2 - 47.0 lb-ft)

Hyundai Venue. Front Seat Assembly. Repair procedures

[Rear]

Hyundai Venue. Front Seat Assembly. Repair procedures

2.	Separate the front seat main connector (A), side airbag connector (B) and front seat belt buckle connector (C).

To install, reverse removal procedure.

The installation procedures of seat mounting bolts

•	Push the seat to the rear end of slides and initially tighten the front mounting bolts.

•	Push the seat to the front end of slides and completely tighten the rear mounting bolts.

•	Send the seat to the rear end again to completely tighten the front mounting bolts.

•	Check the seat for smooth movement.

•	For the non-automatic slide seats, check the seats are fixed at each designated fixing position.

Front Seat Assembly. Components and components location

Front Seat Shield Outer Cover. Components and components location

Other information:

Hyundai Venue (QX) (2020-2025) Service Manual: Repair procedures

Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS...

Hyundai Venue (QX) (2020-2025) Owners Manual: USB charger

The USB charger is designed to recharge batteries of small size electrical devices using a USB cable. The electrical devices can be recharged when the ignition switch or the Engine Start/Stop button is in the ACC, ON or START position. The battery charging state may be monitored on the electrical device...