Hyundai Venue: Front Seat Belt / Front Seat Belt Pretensioner. Repair procedures
| • |
When installing the belt, make sure not to damage the pretensioner.
|
|
| 1. |
Loosen the mounting bolt and remove the front seat belt lower anchor
(A).
|
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)
|

|
| 2. |
Remove the center pillar lower trim.
(Refer to Interior Trim - "Center Pillar Trim")
|
| 3. |
Remove the center pillar upper trim.
(Refer to Interior Trim - "Center Pillar Trim")
|
| 4. |
Loosen the mounting bolt and remove the front belt upper anchor (A).
|
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)
|

|
| 5. |
Separate the pretensioner, airbag connector (A), loosen the mounting
bolts and remove the front seat belt pretensioner (B).
|
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)
|

|
| 6. |
To install, reverse removal procedure.
| •
|
After installing the front seat belt retractor, check
that the air bag warning indicator illuminates for about
6 seconds when the ignition is ON and then goes out.
|
| •
|
Make sure the connector is plugged in properly.
|
| •
|
Replace any damaged clips (or pin-type retainers).
|
|
|
Other information:
Check LKA system
If there is a problem with the system a message will appear for a few seconds.
If the problem continues LKA system failure indicator will illuminate.
LKA system failure indicator
LKA system failure indicator (yellow) will illuminate if the LKA system is not
working properly...
..
Categories
Vehicle Identification Number (vin)

Frame number
read more