Hyundai Venue: Engine Electrical System / General Information
Hyundai Venue (QX) (2020-2022) Service Manual / Engine Electrical System / General Information
Specifications
Specification
Ignition System
Ignition Coil
Item
Specification
Primary Coil Resistance (Ω)
0...
Other information:
Hyundai Venue (QX) (2020-2022) Service Manual: Rear Door Inside Handle. Repair procedures
Removal 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Cut the heat welds with a knife and remove the front door inside handle (A). • Cut the heat welds with a knife, paying attention to damage...
Hyundai Venue (QX) (2020-2022) Service Manual: Front Oil Seal. Repair procedures
Removal and Installation 1. Remove the crankshaft damper pulley. (Refer to Timing System - "Crankshaft Damper Pulley") 2. Remove the front oil seal. • Using the SST (09455-21200), reassemble the timing chain cover oil seal (A)...
Categories
- Manuals Home
- 1st Generation Venue Owners Manual
- 1st Generation Venue Service Manual
- Liftgate
- Operating Door Locks from Outside the Vehicle
- Remote start
- New on site
- Most important about car
Air bag collision sensors
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:
Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.
Copyright © 2022 www.hvenueqx.com