Hyundai Venue (QX): Timing System / Idler. Components and components location
| Components |
| 1. Idler |
Removal 1. Disconnect the battery negative terminal. 2. Loosen the mounting bolts (A) and then, turn the adjusting bolt (B) clockwise in loose tension.
Removal and Installation 1. Remove the drive belt. (Refer to Timing System - "Dreve Belt") 2.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures
Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.
Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Description and operation
Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Operating Door Locks from Outside the Vehicle
- Electronic Stability Control (ESC)
- Maintenance
- New on site
- Most important about car
