Hyundai Venue: Emergency Situations / If the Engine Will not Start

Hyundai Venue (QX) (2020-2024) Owners Manual / Emergency Situations / If the Engine Will not Start

If the Engine Doesn’t Turn Over or Turns Over Slowly

Be sure the shift lever is in N (Neutral) or P (Park). The engine starts only when the shift lever is in N (Neutral) or P (Park).
Check the battery connections to be sure they are clean and tight.
Turn on the interior light. If the light dims or goes out when you operate the starter, the battery is drained. Do not push or pull the vehicle to start it. This could cause damage to your vehicle. See instructions for “Jump Starting” provided in this chapter.

CAUTION

Push or pull starting the vehicle may cause the catalytic converter to overload which can lead to damage to the emission control system.

If the Engine Turns Over Normally but Doesn’t Start

Check the fuel level and add fuel if necessary.

If the engine still does not start, have your vehicle checked by an authorized HYUNDAI dealer.

In Case of an Emergency While Driving

If the Engine Stalls While Driving Reduce your speed gradually, keeping a straight line. Move cautiously off the road to a safe place. Turn on your hazard warning flasher...

Jump Starting

Jump starting can be dangerous if done incorrectly. Follow the jump starting procedure in this section to avoid serious injury or damage to your vehicle...

Other information:

Hyundai Venue (QX) (2020-2024) Service Manual: Repair procedures

Inspection Front Door Lock Module Inspection 1. Remove the front door trim. (Refer to Body - "Front Door Trim") 2. Remove the front door module. (Refer to Body - "Front Door Module") 3...

Hyundai Venue (QX) (2020-2024) Service Manual: Special service tools

Special Service Tools Tool (Number and name) Illustration Use Crankshaft front oil seal installer (09455-21200) Installation of the front oil seal Valve stem oil seal installer (09222-2B100) Installation of the valve stem oil seal Valve spring compressor and holder A : (09222-3K000) B : (09222-3K100) Removal and installation of the intake or exhaust valve Crankshaft rear oil seal installer A : (09231-H1100) B : (09231-2B200) Installation of the crankshaft rear oil seal Ring gear stoppper A : (09231-3N100) B : (09231-2B100) Removal and installation of crankshaft pulley bolt...

Categories

Air bag collision sensors

WARNING

To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:

Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.

Hyundai Venue. Air bag collision sensors