Hyundai Venue: Blower / Intake Actuator. Components and components location

Replacement
1.
Open the glove box.
2.
Press both sides of the glove box (A) and take it out...
Description
The intake actuator is located at the blower unit. It regulates the intake door
by a signal from the control unit. Pressing the intake selection switch will
shift between recirculation and fresh air modes...
Other information:
(1) Jack handle
(2) Jack
(3) Wheel lug nut wrench
(4) Towing hook
The jack, jack handle, and wheel lug nut wrench are stored in the luggage compartment
under the luggage box cover.
The jack is provided for emergency tire changing only.
Turn the winged hold down bolt counterclockwise to remove the spare tire...
Removal and Installation
1.
Disconnect the battery negative terminal.
2.
Loosen the drain plug, and drain the engine coolant. Remove the radiator
cap to drain with speed.
3...
Categories
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious
injury or death:
Do not hit or allow any objects to impact the locations where air bags
or sensors are installed.
Do not perform maintenance on or around the air bag sensors. If the location
or angle of the sensors is altered, the air bags may deploy when they should
not or may not deploy when they should.
Do not install bumper guards or replace the bumper with a nongenuine
HYUNDAI parts. This may adversely affect the collision and air bag deployment
performance.
Place the ignition switch in the LOCK/OFF or ACC position when the vehicle
is being towed to prevent inadvertent air bag deployment.
Have all air bag repairs conducted by an authorized HYUNDAI dealer.

read more