Hyundai Venue (QX): Steering wheel / Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Steering System / Steering wheel / Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Turn the steering wheel so that the front wheels can face straight ahead.
3.
Remove the drive airbag module.
(Refer to Restraint - "Drive Air Bag Module")
4.
Disconnect the steering wheel connector (A).

Hyundai Venue. Repair procedures
5.
Remove the steering wheel lock bolt (A) and then separate the steering wheel from the steering column.
Tightening torque :
44.1 - 49.0 N.m (4.5 - 5.0 kgf.m, 32.5 - 36.2 lb-ft)

Hyundai Venue. Repair procedures
Disassembly
1.
Loosen the screw and then remove the lower cover (A).

Hyundai Venue. Repair procedures
2.
Disconnect the remote control switch connector (A).

Hyundai Venue. Repair procedures

Hyundai Venue. Repair procedures
3.
Loosen the screw and then remove the remote control switch (A).

Hyundai Venue. Repair procedures
4.
Loosen the screw and then remove the steering wheel bezel (A).

Hyundai Venue. Repair procedures
Installation
1.
Install in the reverse order of removal.

    Components 1. Drive air bag module (DAB) 2. Steering wheel 3. Wiring 4. Bezel 5. Remote control switch 6.

    Components 1. Heated steering wheel switch

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures

    Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.

    Hyundai Venue (QX) (2020-2026) Service Manual: Parking Distance Warning (PDW) Sensor. Repair procedures

    Removal 1. Remove the bumper cover. (Refer to Body - "Front Bumper Cover") 2. Disconnect the connector (A) from the PDW sensor. [L - Type] Installation 1.

    Categories

     
    Copyright В© 2026 www.hvenueqx.com - 0.0126