Hyundai Venue (QX): Lubrication System / Oil Level Gauge & Pipe. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Mechanical System / Lubrication System / Oil Level Gauge & Pipe. Repair procedures

Removal and Installation
1.
Remove the oil level gauge & rod (A).
Tightening torque :
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

Hyundai Venue. Oil Level Gauge & Pipe. Repair procedures
2.
Install in the reverse order of removal.

    Removal 1. Disconnect the battery negative terminal. 2. Remove the engine room under cover.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Description and operation

    Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.

    Hyundai Venue (QX) (2020-2026) Service Manual: Blower Resistor (Manual). Repair procedures

    Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.

    Categories

     
    Copyright В© 2026 www.hvenueqx.com - 0.0102