Hyundai Venue: Parking Brake System / Parking Brake Cable. Repair procedures

Hyundai Venue (QX) (2020-2025) Service Manual / Brake System / Parking Brake System / Parking Brake Cable. Repair procedures

Removal
[Rear Drum Brake Type]
1.
Disconnect the negative (-) battery cable.
2.
Release the parking brake.
3.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
4.
Loosen the parking cable adjust nut (A).

Hyundai Venue. Parking Brake Cable. Repair procedures
5.
Separate the parking brake cable(B) from the Equalizer assembly (A).

Hyundai Venue. Parking Brake Cable. Repair procedures

Hyundai Venue. Parking Brake Cable. Repair procedures   
•
Parking brake lever in the car must be in fully loosened position.
6.
Remove the rear drum brake.
(Refer to Brake System - "Rear Drum Brake")
7.
Remove the clip (A).

Hyundai Venue. Parking Brake Cable. Repair procedures
8.
Remove the rear parking cable bracket mounting bolts (A).
Tightening torque :
8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb-ft)

Hyundai Venue. Parking Brake Cable. Repair procedures
9.
Remove the floor under cover (A).
Tightening torque :
3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)

Hyundai Venue. Parking Brake Cable. Repair procedures
10.
Loosen the parking brake cable bracket bolts (A) and remove the parking brake cable.
Tightening torque :
8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb-ft)

Hyundai Venue. Parking Brake Cable. Repair procedures
[Rear Disc Brake Type]
1.
Disconnect the negative (-) battery cable.
2.
Release the parking brake.
3.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
4.
Loosen the parking cable adjust nut (A).

Hyundai Venue. Parking Brake Cable. Repair procedures
5.
Separate the parking brake cable(B) from the Equalizer assembly (A).

Hyundai Venue. Parking Brake Cable. Repair procedures

Hyundai Venue. Parking Brake Cable. Repair procedures   
•
Parking brake lever in the car must be in fully loosened position.
6.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
7.
Remove the rear wheel and tire (A) from the rear hub.
Tightening torque :
107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)
Hyundai Venue. Parking Brake Cable. Repair procedures   
•
Be careful not to damage the hub bolts when removing the rear wheel and tire (A).

Hyundai Venue. Parking Brake Cable. Repair procedures
8.
Disconnect the parking cable (B) after remove the parking brake cable fixing clip (A).

Hyundai Venue. Parking Brake Cable. Repair procedures
9.
Loosen the mounting bolt (A) and than remove the parking cable bracket.
Tightening torque :
19.6 - 29.4 N.m (2.0 - 3.0 kgf.m, 14.5 - 21.7 lb-ft)

Hyundai Venue. Parking Brake Cable. Repair procedures
10.
Remove the floor under cover (A).
Tightening torque :
3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)

Hyundai Venue. Parking Brake Cable. Repair procedures
11.
Loosen the parking brake cable mouting bolts and then remove the parking brake cable (A).
Tightening torque :
8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb-ft)

Hyundai Venue. Parking Brake Cable. Repair procedures
Installation
[Rear Drum Brake Type]
1.
Depress the brake pedal several times to set the self-adjusting brake.
Hyundai Venue. Parking Brake Cable. Repair procedures   
•
For Drum Brake type, shoe clearance is automatically adjusted by the adjuster and adjusting lever.
[Rear Disc Brake Type]
1.
To install, reverse removal procedure.
2.
Tension the parking brake cable by tightening the adjusting nut, until the operating levers on both calipers lift from the stop, up to a distance of (A) and (D) between operating lever (B) and stopper (C).
Distance (A + D) : Max. 3 mm (0.12 in)

Hyundai Venue. Parking Brake Cable. Repair procedures
3.
Release the parking brake lever fully, and check that parking brakes do not drag when the rear wheels are turned. Readjust if necessary.
4.
Make sure that the parking brakes are fully applied when the parking brake lever is pulled up fully.

    Parking Brake Switch. Repair procedures

    Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Release the parking brake...

    ABS(Anti-Lock Brake System)

    ..

    Other information:

    Hyundai Venue (QX) (2020-2025) Service Manual: Description and operation


    Description The ECM (Electro Chromatic inside rear view Mirror) is for dimming the reflecting light from a vehicle behind at night, Preventing glare from the light. The forward facing sensor detects brightness of the surroundings, while the rearward looking sensor detects the strength of the reflecting light and adjusts the reflexibility of the mirror in the range of 7 - 85%...

    Hyundai Venue (QX) (2020-2025) Service Manual: Accelerator Position Sensor (APS). Specifications


    ..

    Categories

    Air bag collision sensors

    WARNING

    To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:

    Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.

    Hyundai Venue. Air bag collision sensors

    read more


     
    Copyright © 2025 www.hvenueqx.com