Hyundai Venue (QX): Roof Trim / Assist Handle. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Roof Trim / Assist Handle. Repair procedures

Replacement
Hyundai Venue. Assist Handle. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
After lifting up the assist handle caps and loosening the mounting screws, remove the assist handle (A).

Hyundai Venue. Assist Handle. Repair procedures
2.
To install, reverse removal procedure.

    Component Location 1. Assist handle

    Component Location 1. Roof Trim Assembly

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Evaporator Temperature Sensor. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure the resistance between terminal "+" and "-" of the evaporator temperature sensor.

    Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures

    Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0092