Hyundai Venue (QX): Engine Control System / Camshaft Position Sensor (CMPS). Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Control / Fuel System / Engine Control System / Camshaft Position Sensor (CMPS). Repair procedures

Inspection
1.
Check signal waveform of CKPS and CMPS using a scan tool.
Specification : Refer to "Waveform"
Removal
Hyundai Venue. Camshaft Position Sensor (CMPS). Repair procedures   
•
DON’T remove the camshaft position sensor during engine running or right after engine stops, or a scald by the flowed out engine oil may occur.
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the camshaft position sensor connector (A).
3.
Remove the installation bolt (B), and then remove the sensor.
Camshaft position sensor installation bolt :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
[Bank 1 / Intake]

Hyundai Venue. Camshaft Position Sensor (CMPS). Repair procedures

[Bank 1 / Exhaust]

Hyundai Venue. Camshaft Position Sensor (CMPS). Repair procedures
Installation
Hyundai Venue. Camshaft Position Sensor (CMPS). Repair procedures   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Hyundai Venue. Camshaft Position Sensor (CMPS). Repair procedures   
•
Apply the engine oil to the O-ring.
Hyundai Venue. Camshaft Position Sensor (CMPS). Repair procedures   
•
Insert the sensor in the installation hole and be careful not to damage when installation.
Hyundai Venue. Camshaft Position Sensor (CMPS). Repair procedures   
•
Be careful not to damage the sensor housing and the connector.
•
Be careful not to damage the O-ring.
1.
Install in the reverse order of removal.

    Circuit Diagram [M/T] [A/T] Harness Connector

    Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Compressor oil. Repair procedures

    Oil Specification 1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor (PAG) oil varies according to compressor model.

    Hyundai Venue (QX) (2020-2026) Service Manual: Ambient Temperature Sensor. Description and operation

    Description The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0172