Hyundai Venue (QX): Interior Trim / Center Pillar Trim. Repair procedures
[Center pillar lower trim]
| • |
Put on gloves to prevent hand injuries.
|
| • |
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
| • |
Use a plastic panel removal tool to remove interior trim pieces
without marring the surface.
|
| • |
Take care not to bend or scratch the trim and panels.
|
|
| 1. |
Carefully remove the front door body side weatherstrip.
|
| 2. |
Carefully remove the rear door body side weatherstrip.
|
| 3. |
Remove the front door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
|
| 4. |
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
|
| 5. |
Using a screwdriver or remover, remove the center pillar lower trim
(A).
|
| 6. |
To install, reverse removal procedure.
| •
|
Replace any damaged clips (or pin-type retainers).
|
|
|
[Center pillar upper trim]
| • |
Put on gloves to prevent hand injuries.
|
| • |
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
| • |
Use a plastic panel removal tool to remove interior trim pieces
without marring the surface.
|
| • |
Take care not to bend or scratch the trim and panels.
|
|
| 1. |
Remove the center pillar lower trim.
(Refer to Interior Trim - "Center Pillar Trim")
|
| 2. |
Loosen the mounting bolt and remove the front seat belt lower anchor
(A).
|
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)
|
|
| 3. |
Using a flat-tip screwdriver and remove the center pillar upper trim
(A).
|
| 4. |
To install, reverse removal procedure.
| •
|
Replace any damaged clips (or pin-type retainers).
|
|
|
Component Location
1. Center pillar lower trim
2. Center pillar upper trim
Component Location
1. Rear transverse trim
Other information:
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the steering column upper and lower shroud panel.
Description and Operation
Blcok Diagram
•
This system monitors the driving situations through the radar
and the camera. Thus, for a situation out of the sensing range,
the system may not normally operate.
