| Component Location |

| 1. Horn switch 2. Horn relay |
3. Horn 4. Clock spring |
Removal 1. Remove the front bumper cover. (Refer to Body - "Front Bumper Cover") 2. Disconnect the multifunction switch connector and then remove the low horn (A).
Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.
Component Location 1. Heater unit assembly Compoents 1. Mode control actuator 2. Heater core case 3. Center duct seal 4. PTC heater 5. Heater core assembly 6. Heater case [LH] 7.