| Component Location |

| 1. Power door mirror 2. Power door mirror control (LH/RH) |
3. Power door mirror switch |
Circuit Diagram Circuit Diagram [Adjust + Folding] [Adjust]
Component Location [Engine Room] 1. Condenser 2. Discharge hose 3. Suction & Liquid tube assembly 4. Compressor 5. Service port (High pressure) 6. A/C Pressure transducer (APT) 7. Service port (Low pressure) 8.
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.