Hyundai Venue (QX): Ignition Lock Switch / Concentric Slave Cylinder Assembly. Repair procedures

Hyundai Venue (QX) (2020-2025) Service Manual / Clutch System / Ignition Lock Switch / Concentric Slave Cylinder Assembly. Repair procedures

Removal
1.
Remove the manual transaxle assembly.
(Refer to Manual Transaxle System - "Manual Transaxle")
2.
Loosen the bolts and then removing the concentric slave cylinder assembly (A) from the clutch housing.
Tightening torque :
19.6 - 26.5 N.m (2.0 - 2.7 kgf.m, 14.2 - 19.5 lb-ft)

Hyundai Venue. Concentric Slave Cylinder Assembly. Repair procedures
Installation
1.
To install, reverse the removal procedures.
Hyundai Venue. Concentric Slave Cylinder Assembly. Repair procedures   
•
Install the concentric slave cylinder bolts. Not to be bent or twisted, Tighten them in diagonal directions.
•
Cup, Inner surface of body and outer surface of tube guide must be free from flaws.
•
When it is assembled, it must be free from invasive foreign matters and oil leakage.
Hyundai Venue. Concentric Slave Cylinder Assembly. Repair procedures   
•
When it is installed, assembly oil must be applied adequately to inner surface of body and outer surface of tube guide.
Specified fluid : KLUBER 9R1007
Adjustment
Concentric Slave Cylinder Air Bleeding Procedure
1.
After disconnecting a cap from the concentric slave cylinder air bleeder, insert a vinyl hose in the plug.
2.
Refill the reservoir tank with the specified fluid.
Hyundai Venue. Concentric Slave Cylinder Assembly. Repair procedures   
•
Use the specified fluid. Avoid mixing different brands of fluid.
Specified fluid : SAE J1703 (DOT 3 or DOT 4)
3.
Pump the clutch pedal about 10 times.
4.
Loosen the air bleed screw (A) at hold down the clutch pedal to allow air to escape from the clutch system. Then tighten the air bleed screw.

Hyundai Venue. Concentric Slave Cylinder Assembly. Repair procedures
5.
Repeat the step 2 - 4 until there is no bubble in the fluid.

    Removal 1. Separate the push rod (A) from the clutch pedal. 2. Turn ignition switch OFF and disconnect the negative (-) battery cable.

    Other information:

    Hyundai Venue (QX) (2020-2025) Service Manual: Description and operation

    Description The immobilizer system will disable the vehicle unless the proper ignition key is used, in addition to the currently available anti-theft systems such as car alarms, the immobilizer system aims to drastically reduce the rate of auto theft.

    Hyundai Venue (QX) (2020-2025) Service Manual: Rear Corner Radar Unit. Repair procedures

    Removal    lf replacement of the rear corner radar unit bracket or extension wire is required, replace the defective part only with a new one. 1.

    Categories

     
    Copyright © 2025 www.hvenueqx.com - 0.0125