Hyundai Venue (QX): Crash Pad / Crash Pad Side Cover. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Crash Pad / Crash Pad Side Cover. Repair procedures

Replacement
Hyundai Venue. Crash Pad Side Cover. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
Hyundai Venue. Crash Pad Side Cover. Repair procedures   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front door body side weatherstrip.
2.
Using a flat-tip screwdriver or remover and remove the crash pad side cover (A).
[RH]

Hyundai Venue. Crash Pad Side Cover. Repair procedures

[LH]

Hyundai Venue. Crash Pad Side Cover. Repair procedures
3.
To install, reverse removal procedure.
Hyundai Venue. Crash Pad Side Cover. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Replacement [Steering column shroud upper panel]    • Put on gloves to prevent hand injuries.

    Replacement    • Put on gloves to prevent hand injuries.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Troubleshooting

    Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor. Use the table below to help you find the cause of the problem.

    Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Description and operation

    Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0116