Hyundai Venue (QX): Crash Pad / Steering Column Shroud Panel. Repair procedures
[Steering column shroud upper panel]
| • |
Put on gloves to prevent hand injuries.
|
| • |
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
| • |
Use a plastic panel removal tool to remove interior trim pieces
without marring the surface.
|
| • |
Take care not to bend or scratch the trim and panels.
|
|
| 1. |
Remove the cluster fascia panel.
(Refer to Crash Pad - "Cluster Fascia Panel")
|
| 2. |
Using a flat-tip screwdriver and remove the steering column shroud upper
panel (A).
|
| 3. |
To install, reverse removal procedure.
|
[Steering column shroud lower panel]
| • |
Put on gloves to prevent hand injuries.
|
| • |
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
| • |
Use a plastic panel removal tool to remove interior trim pieces
without marring the surface.
|
| • |
Take care not to bend or scratch the trim and panels.
|
|
| 1. |
Remove the crash pad lower panel.
(Refer to Crash Pad - "Crash Pad Lower Panel")
|
| 2. |
Loosen the mounting screws by turning the steering wheel to the left
and right, and remove the steering column shroud lower panel (A).
|
| 3. |
To install, reverse removal procedure.
|
Replacement
•
Put on gloves to prevent hand injuries.
Replacement
•
Put on gloves to prevent hand injuries.
Other information:
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the glove box.
(Refer to Body - "Glove Box Housing")
3.
Remove the smart key unit (A) after loosening the nuts.
Component Location
1. Heater unit assembly
Compoents
1. Mode control actuator
2. Heater core case
3. Center duct seal
4. PTC heater
5. Heater core assembly
6. Heater case [LH]
7.
