Hyundai Venue (QX): Passenger Airbag (PAB) Module / Curtain Airbag (CAB) Module. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Restraint / Passenger Airbag (PAB) Module / Curtain Airbag (CAB) Module. Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2.
Remove the roof trim.
(Refer to Body - "Roof Trim Assembly")
3.
Remove the curtain airbag after disconnecting the curtain airbag harness connector and loosening the mounting bolts.

Hyundai Venue. Curtain Airbag (CAB) Module. Repair procedures
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Tighten the curtain airbag mounting bolts.
Tightening torque
Bolt : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
Hyundai Venue. Curtain Airbag (CAB) Module. Repair procedures   
•
Never twist the airbag module during installation. If the airbag module is twisted, the airbag module may operate abnormally.
4.
Connect the curtain airbag connector.
5.
Install the roof trim.
(Refer to Body - "Roof Trim Assembly")
6.
Reconnect the battery negative cable.
7.
After installing the curtain airbag (CAB), confirm proper system operation :
•
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

    Components 1. Curtain Air Bag (CAB)

    Airbag Disposal When you scrap a vehicle equipped with an airbag, you must deploy it first. When you deploy an airbag, you need to have a skilled mechanic do the work.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Troubleshooting

    Diagnosis with Diagnostic tool 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (Diagnostic tool). The diagnostic system (Diagnostic tool) provides the following information.

    Hyundai Venue (QX) (2020-2026) Service Manual: Cruise Control (CC) Switch. Repair procedures

    Inspection 1. Loosen the cruise control switch connector. 2. Check for resistance between terminals in each switch position. Switch Connector terminal Resistance (±5%) Cancel

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0129