Hyundai Venue (QX): Manifold Absolute Pressure Sensor (MAPS) / Description and operation
Hyundai Venue (QX) (2020-2026) Service Manual / Engine Control / Fuel System / Engine Control System / Manifold Absolute Pressure Sensor (MAPS) / Description and operation
| Description |
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and
is installed on the surge tank. It senses absolute pressure of the surge tank
and transfers the analog signal proportional to the pressure to the ECM. By
using this signal, the ECM calculates the intake air quantity and engine speed.
The MAPS consists of a piezo-electric element and a hybrid IC amplifying the
element output signal. The element is silicon diaphragm type and adapts pressure
sensitive variable resistor effect of semi-conductor. Because 100% vacuum and
the manifold pressure apply to both sides of the sensor respectively, this sensor
can output analog signal by using the silicon variation proportional to pressure
change.
Specification Pressure [kPa (kgf/cm², psi)] Output Voltage (V) 20.0 (0.20, 2.9) 0.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.
Hyundai Venue (QX) (2020-2026) Service Manual: Blower Resistor (Manual). Repair procedures
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Normal Maintenance Schedule
- Repair procedures
- Front Suspension System
- New on site
- Most important about car
Copyright © 2026 www.hvenueqx.com - 0.0183