Hyundai Venue (QX): Body Side Molding / Door Garnish. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Body Side Molding / Door Garnish. Repair procedures

Replacement
Hyundai Venue. Door Garnish. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Take care not to scratch the body surface.
1.
Using a remover and remove the front door garnish (A) and rear door garnish (B).

Hyundai Venue. Door Garnish. Repair procedures
2.
To install, reverse removal procedure.
Hyundai Venue. Door Garnish. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Replacement    • Put on gloves to prevent hand injuries.

    Replacement    • Put on gloves to prevent hand injuries.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures

    Inspection 1. Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column. 2. Check for continuity between the terminals. 3.

    Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.013