Hyundai Venue (QX): Body Side Molding / Side Sill Molding. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Body Side Molding / Side Sill Molding. Repair procedures

Replacement
Hyundai Venue. Side Sill Molding. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Take care not to scratch the body surface.
1.
Remove the fender garnish.
(Refer to Fender Garnish)
2.
Remove the quarter garnish.
(Refer to Quarter Garnish)
3.
Using a remover and remove the side sill molding (A).

Hyundai Venue. Side Sill Molding. Repair procedures
4.
To install, reverse removal procedure.
Hyundai Venue. Side Sill Molding. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Replacement    • Put on gloves to prevent hand injuries.

    Replacement    • Put on gloves to prevent hand injuries.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures

    Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.

    Hyundai Venue (QX) (2020-2026) Service Manual: Blower Resistor (Manual). Repair procedures

    Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0168