| Removal and Installation |
| 1. |
Remove the engine cover (A).
|
| 2. |
Installation is reverse order of removal
|
Removal and Installation 1. Remove the engine room under cover (A). Tightening torque : 3.
Component Location 1. Heater unit assembly Compoents 1. Mode control actuator 2. Heater core case 3. Center duct seal 4. PTC heater 5. Heater core assembly 6. Heater case [LH] 7.
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4.