Hyundai Venue (QX): Front Bumper / Front Bumper Beam Assembly. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Front Bumper / Front Bumper Beam Assembly. Repair procedures

Replacement
Hyundai Venue. Front Bumper Beam Assembly. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front bumper cover.
(Refer to Front Bumper - "Front Bumper Cover")
2.
Separate the ambient temperature sensor connector (A) and loosen the mounting clips.

Hyundai Venue. Front Bumper Beam Assembly. Repair procedures
3.
Press the lock pin and separate the front radar connector (A) and loosen the mounting clips.

Hyundai Venue. Front Bumper Beam Assembly. Repair procedures
4.
Loosen the mounting bolts, nuts and remove the front bumper beam assembly (A).
Hyundai Venue. Front Bumper Beam Assembly. Repair procedures   
•
When removing the front bumper rail, engage the fastening bolt for the front bumper rail to align the front end module and keep it in order.

Hyundai Venue. Front Bumper Beam Assembly. Repair procedures
5.
To install, reverse removal procedure.
Hyundai Venue. Front Bumper Beam Assembly. Repair procedures   
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Front bumper beam assembly

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures

    Refrigerant System Service Basics (R-134a) Refrigerant Recovery Use only service equipment that is U.L-listed and is certified to meet the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air conditioning system.

    Hyundai Venue (QX) (2020-2026) Service Manual: Ambient Temperature Sensor. Description and operation

    Description The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0181