| Replacement |
| 1. |
Pull down the front door window glass to the lowest level by pressing
the power window glass switch.
|
| 2. |
Remove the outside rear view mirror.
(Refer to Mirror - "Outisde Rear View Mirror")
|
| 3. |
Using a remover or flat-tip screwdriver and remove the front door belt
outside weatherstrip (A).
|
| 4. |
To install, reverse removal procedure.
|
Replacement • When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.
Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2.
Component Location 1. Heater unit assembly Compoents 1. Mode control actuator 2. Heater core case 3. Center duct seal 4. PTC heater 5. Heater core assembly 6. Heater case [LH] 7.
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.