Hyundai Venue (QX): Front Door / Front Door Outside Handle. Repair procedures

Replacement
Hyundai Venue. Front Door Outside Handle. Repair procedures   
•
When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.
•
Take care not to scratch the body surface.
1.
Remove the plug hole (A) and loosen the outside handle mounting bolt.
Tightening torque :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

Hyundai Venue. Front Door Outside Handle. Repair procedures

2.
Remove the front door exterior handle (A) by pushing it rearwards.

Hyundai Venue. Front Door Outside Handle. Repair procedures

3.
Press the lock pin and separate the front door outside handle connector (A).

Hyundai Venue. Front Door Outside Handle. Repair procedures

4.
To install, reverse removal procedure.
Hyundai Venue. Front Door Outside Handle. Repair procedures   
•
Make sure the connector is connected properly.
•
Make sure the door locks / unlocks and opens / closes properly.
•
Be sure to install the outside handle pad (A) between the outside handle and the door panel.

Hyundai Venue. Front Door Outside Handle. Repair procedures

    Component Location 1. Front door outside handle

    Replacement 1. Pull down the front door window glass to the lowest level by pressing the power window glass switch.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Special service tools

    Special Service Tools Tool (Number and name) Illustration Use 09977-3R000 Disc & hub assembly bolt remover Removal and installation of disc & hub assembly.

    Hyundai Venue (QX) (2020-2026) Service Manual: Blower Unit. Components and components location

    Component Location 1. Blower unit assembly Component Location 1. Intake seal 2. Intake upper case 3. Intake actuator 4. Intake door 5. Intake lower case 6. Blower pad 7.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0126