| Replacement |
| 1. |
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
|
| 2. |
Remove the front door belt inside weatherstrip (A).
|
| 3. |
To install, reverse removal procedure.
|
Replacement 1. Pull down the front door window glass to the lowest level by pressing the power window glass switch.
Replacement [Front door side weatherstrip] 1. Loosen the front door checker (B) mounting bolt. Tightening torque : 21.
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater unit assembly. (Refer to Heater - "Heater Unit") 3. Separate the evaporator temperature sensor connector (A), loosen the mounting screws and remove the eva