Hyundai Venue (QX): Front Door / Front Door Inside Handle. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Front Door / Front Door Inside Handle. Repair procedures

Removal
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Cut the heat welds with a knife and remove the front door inside handle (A).

Hyundai Venue. Front Door Inside Handle. Repair procedures

Hyundai Venue. Front Door Inside Handle. Repair procedures   
•
Cut the heat welds with a knife, paying attention to damage.

Hyundai Venue. Front Door Inside Handle. Repair procedures
Installation
1.
Refit the front door interior handle.
2.
Refit the screws on the heat welds.
Hyundai Venue. Front Door Inside Handle. Repair procedures   
•
Since there is no groove to mount the screw, place the screw driver in a straight line and install it.

Hyundai Venue. Front Door Inside Handle. Repair procedures

    Replacement    • When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.

    Component Location 1. Front door outside handle

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: In-car Sensor. Repair procedures

    Diagnosis With GDS 1. The heating, ventilation and air conditioning can be quickly diagnosed failed parts with vehicle diagnostic system (GDS). ※ The diagnostic system (GDS) provides the following information.

    Hyundai Venue (QX) (2020-2026) Service Manual: Ambient Temperature Sensor. Description and operation

    Description The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0168