Hyundai Venue (QX): Front Door / Front Door Module. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Front Door / Front Door Module. Repair procedures

Replacement
Hyundai Venue. Front Door Module. Repair procedures   
•
When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.
•
Take care not to scratch the body surface.
1.
Remove the front door window glass.
(Refer to Front Door - "Front Door Window Glass")
2.
Remove the front door outside handle.
(Refer to Front Door - "Front Door Outside Handle")
3.
Loosen the front door outside handle screw (A).

Hyundai Venue. Front Door Module. Repair procedures
4.
Loosen the front door latch screws.
Tightening torque :
7.8 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.8 - 8.0 lb-ft)

Hyundai Venue. Front Door Module. Repair procedures
5.
Press the lock pin and separate the front door main connector (A).

Hyundai Venue. Front Door Module. Repair procedures
6.
Loosen the front door moodule bolts and remove the front door module (A).
Tightening torque :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

Hyundai Venue. Front Door Module. Repair procedures
7.
Disconnect the various connector fron the front door module and separate the front door module wiring harness (A).
8.
Remove the front door latch assembly.
(Refer to Front Door - "Front Door Latch Assembly")
9.
Remove the front power window motor.
(Refer to Body Electrical System - "Power Window Motor")
10.
To install, reverse removal procedure.
Hyundai Venue. Front Door Module. Repair procedures   
•
Make sure connectors are connected properly and each rod is connected securely.
•
Make sure the door locks / unlocks and opens / closes properly.

    Component Location 1. Front door module

    Removal 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Cut the heat welds with a knife and remove the front door inside handle (A).

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Antenna Coil. Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the driver crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the steering column upper and lower shroud panel.

    Hyundai Venue (QX) (2020-2026) Service Manual: Receiver-Drier. Repair procedures

    Replacement 1. Remove the condenser. 2. Remove the cap (A) on the bottom of the condenser with a L wrench. Tightening torque : 9.81 - 14.71 N.m (1.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0181