Hyundai Venue (QX): Front Door / Front Door Outside Handle. Components and components location
| Component Location |
| 1. Front door outside handle |
Removal 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Cut the heat welds with a knife and remove the front door inside handle (A).
Replacement • When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Heater Unit. Components and components location
Component Location 1. Heater unit assembly Compoents 1. Mode control actuator 2. Heater core case 3. Center duct seal 4. PTC heater 5. Heater core assembly 6. Heater case [LH] 7.
Hyundai Venue (QX) (2020-2026) Service Manual: Intake Actuator. Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Liftgate
- Electronic Stability Control (ESC)
- Repair procedures
- New on site
- Most important about car
