Hyundai Venue (QX): Front Door / Front Door Window Glass. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Front Door / Front Door Window Glass. Repair procedures

Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Remove the front door inside weatherstrip (A).

Hyundai Venue. Front Door Window Glass. Repair procedures
3.
Remove the front door outside weatherstrip (A).

Hyundai Venue. Front Door Window Glass. Repair procedures
4.
Remove the plug hole (A).

Hyundai Venue. Front Door Window Glass. Repair procedures
5.
By operating the power window switch, pull down until the glass mounting bolt on plug hole is visible.
Hyundai Venue. Front Door Window Glass. Repair procedures   
•
Be careful not to damage the glass surface.

Hyundai Venue. Front Door Window Glass. Repair procedures
6.
Loosen the mounting bolt and then pull out the front door window glass (A) by tilting it sideways.
Tightening torque :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

Hyundai Venue. Front Door Window Glass. Repair procedures
7.
To install, reverse removal procedure.
Hyundai Venue. Front Door Window Glass. Repair procedures   
•
Roll the glass up and down to see if it moves freely.
•
Adjust glass position as needed.
•
Make sure the door lock and opens properly.
•
Check the glass run channel for damage and replace the damaged channel.

    Component Location 1. Front door window glass

    Component Location 1. Front door module

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: ESCL(Electronic Steering Column Lock). Repair procedures

    Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the steering column upper and lower shrouds.

    Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Description and operation

    Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0117