| Component Location |

| 1. Front door module |
Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2.
Replacement • When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the console upper front garnish. (Refer to Floor Console - "Floor Console Assembly") 3.