Hyundai Venue (QX): Interior Trim / Front Pillar Trim. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Interior Trim / Front Pillar Trim. Repair procedures

Replacement
Hyundai Venue. Front Pillar Trim. Repair procedures   
•
Put on gloves to prevent hand injuries.
Hyundai Venue. Front Pillar Trim. Repair procedures   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front pillar trim.
(1)
To remove the front pillar trim, the fastener remover (A) below must be used.

Hyundai Venue. Front Pillar Trim. Repair procedures
(2)
After slightly lifting up the front pillar trim and putting the tool in, remove the mounting clip (A) by pulling it.
Hyundai Venue. Front Pillar Trim. Repair procedures   
•
Once the front pillar trim is removed, be sure to replace the clips with new ones.

Hyundai Venue. Front Pillar Trim. Repair procedures
(3)
Remove the front pillar trim (A).

Hyundai Venue. Front Pillar Trim. Repair procedures
2.
To install, reverse removal procedure.
Hyundai Venue. Front Pillar Trim. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Front pillar trim

    Component Location 1. Center pillar lower trim 2. Center pillar upper trim

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Blower Resistor (Manual). Repair procedures

    Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.

    Hyundai Venue (QX) (2020-2026) Service Manual: Warning Indicator. Repair procedures

    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. (Refer to Body - "Front door trim") 3. Disconnect the power door mirror connector from the harness 4.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0133