Hyundai Venue (QX): indshield Wiper/Washer / Front Washer Motor. Repair procedures
Front and Rear Washer Motor
| 1. |
With the washer motor connected to the reservoir tank, fill the reservoir
tank with water.
|
Before filling the reservoir tank with water, check the filter
for foreign material or contamination. if necessary, clean the
filter.
|
|
| 2. |
Check that the motor operates normally and the washer motor runs and
water sprays from the front nozzles.
|
| 3. |
If they are abnormal, replace the washer motor.
No
|
Description
|
1
|
Ground
|
2
|
Windshield washer (+)
|
3
|
Rear washer (+)
|

|
| – |
When servicing the washer pump, be careful not to damage the
washer pump seal.
|
| – |
Do not operate the washer pump before filling the washer reservoir.
Failure to do so could result in premature pump failure.
|
|
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front right wheel guard.
(Refer to Body - "Front Wheel Guard")
|
| 3. |
Disconnect the washer motor connector (A) and washer hose (B).

|
| 4. |
Remove the washer reservoir (A) after loosening the mounting bolts.

|
| 5. |
Remove the washer motor (A) from the washer reservoir.

|
| 1. |
Reassemble the washer reservoir.
|
Before installing the pump motor, check the filter for foreign
material or contamination. if necessary, clean the filter into
the pump motor.
|
|
| 2. |
Connect the washer motor connector and washer hose.
|
| 3. |
Reassemble the front bumper cover.
|
Removal
1.
When replacing the wiper blade, press the blade bottom clip button to
remove the blade.
2.
Other information:
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery / recycling / charging station.
3.
When the engine is cool, drain the engine coolant from the radiator.
Replacement
1.
Remove the heater unit assembly.
(Refer to Heater - "Heater Unit")
2.
Loosen the mounting screws and remove the heater core cover (A).
3.