| Replacement |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the center fascia panel.
(Refer to BODY - "Crash pad Center Fascia Panel:)
|
| 3. |
Remove the hazard lamp switch (A) after loosening mounting screws.
|
REMOVAL Front Turn Signal Lamp 1. Disconnect the negative (-) battery terminal. 2. Disconnect the turn signal lamp connector (A).
Description The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature.
Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.