Hyundai Venue (QX): Parking Brake System / Parking Brake Lever. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Brake System / Parking Brake System / Parking Brake Lever. Repair procedures

Removal
1.
Disconnect the negative (-) battery cable.
2.
Release the parking brake.
3.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
4.
Disconnect the parking brake switch connector (A).

Hyundai Venue. Parking Brake Lever. Repair procedures
5.
Separate the parking brake cable(B) from the Equalizer assembly (A).

Hyundai Venue. Parking Brake Lever. Repair procedures
6.
Remove the parking brake lever assembly (A) after loosening the bolts.

Hyundai Venue. Parking Brake Lever. Repair procedures
Installation
1.
Install the parking brake lever assembly.
Tightening torque :
19.6 - 29.4 N.m (2.0 - 3.0 kgf.m, 14.5 - 21.7 lb-ft)

Hyundai Venue. Parking Brake Lever. Repair procedures
2.
Install the parking brake cable (B) to the equalizer assembly (A).

Hyundai Venue. Parking Brake Lever. Repair procedures
3.
Apply a coating of the specified grease to each sliding parts (A) of the ratchet plate or the ratchet pawl.
Specified grease : CASMOLY 623

Hyundai Venue. Parking Brake Lever. Repair procedures
4.
Install the parking brake cable adjuster, then adjust the parking brake lever stroke by turning adjusting nut (A).
Parking brake lever stroke :
5 - 7 clicks (Pull the lever with 196N (20 kgf, 44 lbf)

Hyundai Venue. Parking Brake Lever. Repair procedures

Hyundai Venue. Parking Brake Lever. Repair procedures
5.
Connect the parking brake switch connector (A).

Hyundai Venue. Parking Brake Lever. Repair procedures
6.
Install the floor console assembly.
(Refer to Body - "Floor Console")
Adjustment
1.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
2.
Apply the brake pedal 20 times with the force of 10kgf after bleeding. Then, for the cable to settle in, apply the parking brake full stroke more than 3 times.
3.
Install the parking brake cable adjuster, then adjust the parking brake lever stroke by turning adjusting nut (A).
5 - 7 clicks (Pull the lever with 196N (20 kgf, 44 lbf))

Hyundai Venue. Parking Brake Lever. Repair procedures

Hyundai Venue. Parking Brake Lever. Repair procedures
4.
Tension the parking brake cable by tightening the adjusting nut, until the operating levers on both calipers lift from the stop, up to a distance of (A) and (D) between operating lever (B) and stopper (C).
Distance (A + D) : Max. 3 mm (0.12 in)

Hyundai Venue. Parking Brake Lever. Repair procedures
5.
Release the parking brake lever fully, and check that parking brakes do not drag when the rear wheels are turned. Readjust if necessary.
6.
Make sure that the parking brakes are fully applied when the parking brake lever is pulled up fully.
7.
Install the floor console.
(Refer to Body - "Floor Console")

    Components 1. Parking brake lever 2. Equalizer assembly 3. Parking brake cable 4. Rear Brake caliper

    Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Release the parking brake.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: A/C Pressure Transducer. Repair procedures

    Inspection    • Before measuring the pressure of the refriferant line, check whether the refrigerant amount is charged in accordance with the specified charging amount.

    Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation

    Description Rear view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0119