Hyundai Venue (QX): Parking Brake System / Parking Brake Switch. Repair procedures

Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Release the parking brake.
3.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
4.
Disconnect the parking brake switch connector (A).

Hyundai Venue. Parking Brake Switch. Repair procedures

5.
Loosen the screw and then remove the parking brake switch (A).
Tightening torque :
1.96 - 2.94 N.m (0.2 - 0.3 kgf.m, 1.44 - 2.16 lb-ft)

Hyundai Venue. Parking Brake Switch. Repair procedures

Installation
1.
To install, reverse removal procedure.

    Removal 1. Disconnect the negative (-) battery cable. 2. Release the parking brake. 3.

    Removal [Rear Drum Brake Type] 1. Disconnect the negative (-) battery cable. 2. Release the parking brake.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Refrigerant Line. Repair procedures

    Replacement 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal.

    Hyundai Venue (QX) (2020-2026) Service Manual: In-car Sensor. Repair procedures

    Diagnosis With GDS 1. The heating, ventilation and air conditioning can be quickly diagnosed failed parts with vehicle diagnostic system (GDS). ※ The diagnostic system (GDS) provides the following information.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.018