| Removal |
| 1. |
Disconnect (-) battery terminal.
|
| 2. |
Using a fastener remover (C), remove the mirror (A) as illustration
below.
|
| 3. |
Disconnect the mirror connector (A).
|
| 4. |
Remove the mirror actuator mounting screw.
|
| 5. |
Disconnect the connector (A) and then remove the mirror actuator.
|
| Installation |
| 1. |
Connect the actuator connector and then install the mirror actuator.
|
| 2. |
Install the mirror.
|
| 3. |
Connect (-) battery terminal then check if mirror works normally.
|
INSPECTION 1. Remove the front left door trim. (Refer to Body - "Front Door Trim") 2.
Components 1. Side repeater lamp 2. Warning indicator
Description The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it high speed or low speed.
Removal lf replacement of the rear corner radar unit bracket or extension wire is required, replace the defective part only with a new one. 1.