| INSPECTION |
| 1. |
Remove the front left door trim.
(Refer to Body - "Front Door Trim")
|
| 2. |
Disconnect the mirror connector.
|
| 3. |
Check for continuity between the terminals in each switch position according
to the table.
[Power mirror switch]
[Mirror folding switch]
|
| Removal |
| 1. |
Disconnect (-) battery terminal.
|
| 2. |
Remove the front left door trim.
(Refer to Body - "Front Door Trim")
|
| 3. |
Remove the door mirror switch assembly (A) by pulling out both ends
of the switch holders.
|
| Installation |
| 1. |
Connect the actuator connector and then install the mirror actuator.
|
| 2. |
Install the mirror.
|
| 3. |
Connect (-) battery terminal then check if mirror works normally.
|
Circuit Diagram Circuit Diagram [Adjust + Folding] [Adjust]
Removal 1. Disconnect (-) battery terminal. 2. Using a fastener remover (C), remove the mirror (A) as illustration below.
Refrigerant System Service Basics (R-134a) Refrigerant Recovery Use only service equipment that is U.L-listed and is certified to meet the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air conditioning system.
Description and Operation Blcok Diagram • This system monitors the driving situations through the radar and the camera. Thus, for a situation out of the sensing range, the system may not normally operate.