Hyundai Venue (QX): Power Windows / Power Window Switch. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body Electrical System / Power Windows / Power Window Switch. Repair procedures

Diagnosis with GDS
Diagnosis with GDS
1.
In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (GDS).
The diagnostic system (GDS) provides the following information.
(1)
Fault Code Searching : Checking failure and code number (DTC)
(2)
Data Analysis : Checking the system input/output data state
(3)
Actuation test : Checking the system operation condition
(4)
S/W Management : Controlling other features including system option setting and zero point adjustment
2.
If diagnose the vehicle by GDS, select "DTC Analysis" and "Vehicle".

Hyundai Venue. Power Window Switch. Repair procedures
3.
Select the 'Data Analysis' and 'Car model'.

Hyundai Venue. Power Window Switch. Repair procedures
4.
Select the 'DDM' to search the current state of the input/output data.

Hyundai Venue. Power Window Switch. Repair procedures

Hyundai Venue. Power Window Switch. Repair procedures
5.
To forcibly actuate the input value of the module to be checked, select option 'Actuation Test'.

Hyundai Venue. Power Window Switch. Repair procedures
Removal
Driver/Assist Power Window Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
3.
Remove the power window switch assembly (A) by pulling out both ends of the switch holders.
[Driver]

Hyundai Venue. Power Window Switch. Repair procedures

[Assist]

Hyundai Venue. Power Window Switch. Repair procedures
Rear Power Window Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
3.
Remove the power window switch assembly by pulling out both ends of the switch holders.

Hyundai Venue. Power Window Switch. Repair procedures
Installation
Driver/Assist Power Window Switch
1.
Install the power window switch assembly.
2.
Install the front door trim after connecting the connector.
3.
Connect the negative (-) battery terminal.
Rear Power Window Switch
1.
Install the power window switch assembly.
2.
Install the rear door trim after connecting the connector.
3.
Connect the negative (-) battery terminal.

    Circuit Diagram Driver Power Window Switch [Auto Down + Door Lock] [Auto Up/Down + Safety + Door Lock] Assist & Rear Power Window Switch

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Evaporator Core. Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater unit assembly. (Refer to Heater - "Heater Unit") 3. Separate the evaporator temperature sensor connector (A), loosen the mounting screws and remove the eva

    Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation

    Description and Operation Blcok Diagram    • This system monitors the driving situations through the radar and the camera. Thus, for a situation out of the sensing range, the system may not normally operate.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0127