Hyundai Venue (QX): Front Bumper / Radiator Grill. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Front Bumper / Radiator Grill. Repair procedures

Replacement
Hyundai Venue. Radiator Grill. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front bumper cover.
(Refer to Front Bumper - "Front Bumper Cover")
2.
Remove the front bumper energy absorber (A).

Hyundai Venue. Radiator Grill. Repair procedures
3.
Loosen the mounting screws, remove the front bumper upper cover (A).

Hyundai Venue. Radiator Grill. Repair procedures
4.
Loosen the mounting screws and remove the radiator grill (A).

Hyundai Venue. Radiator Grill. Repair procedures
5.
To install, reverse removal procedure.
Hyundai Venue. Radiator Grill. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Radiator grill

    Component Location 1. Front bumper beam assembly

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures

    Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.

    Hyundai Venue (QX) (2020-2026) Service Manual: Blower Unit. Components and components location

    Component Location 1. Blower unit assembly Component Location 1. Intake seal 2. Intake upper case 3. Intake actuator 4. Intake door 5. Intake lower case 6. Blower pad 7.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0158