| Replacement |
| 1. |
Pull down the front door window glass to the lowest level by pressing
the power window glass switch.
|
| 2. |
Loosen the mounting screw and remove the rear door belt outside weartherstrip
(A).
|
| 3. |
To install, reverse removal procedure.
|
Replacement • When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.
Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2.
Oil Specification 1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor (PAG) oil varies according to compressor model.
Removal lf replacement of the rear corner radar unit bracket or extension wire is required, replace the defective part only with a new one. 1.