Hyundai Venue (QX): Rear Door / Rear Door Inside Handle. Repair procedures

Removal
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Cut the heat welds with a knife and remove the front door inside handle (A).

Hyundai Venue. Rear Door Inside Handle. Repair procedures

Hyundai Venue. Rear Door Inside Handle. Repair procedures   
•
Cut the heat welds with a knife, paying attention to damage.

Hyundai Venue. Rear Door Inside Handle. Repair procedures

Installation
1.
Refit the rear door interior handle.
2.
Refit the screws on the heat welds.
Hyundai Venue. Rear Door Inside Handle. Repair procedures   
•
Since there is no groove to mount the screw, place the screw driver in a straight line and install it.

Hyundai Venue. Rear Door Inside Handle. Repair procedures

    Replacement    • When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.

    Component Location 1. Rear door outside handle

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: ESCL(Electronic Steering Column Lock). Repair procedures

    Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the steering column upper and lower shrouds.

    Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation

    Description and Operation Blcok Diagram    • This system monitors the driving situations through the radar and the camera. Thus, for a situation out of the sensing range, the system may not normally operate.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0184