Hyundai Venue (QX): Rear Door / Rear Door Module. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Module. Repair procedures

Replacement
Hyundai Venue. Rear Door Module. Repair procedures   
•
When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.
•
Take care not to scratch the body surface.
1.
Remove the rear door window glass.
(Refer to Rear Door - "Rear Door Window Glass")
2.
Remove the rear door outside handle.
(Refer to Rear Door - "Rear Door Outside Handle")
3.
Loosen the rear door outside handle screw (A).

Hyundai Venue. Rear Door Module. Repair procedures
4.
Loosen the rear door latch screws.
Tightening torque :
7.8 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.8 - 8.0 lb-ft)

Hyundai Venue. Rear Door Module. Repair procedures
5.
Press the lock pin and separate the rear door main connector (A).

Hyundai Venue. Rear Door Module. Repair procedures
6.
Loosen the rear door moodule bolts and remove the rear door module (A).
Tightening torque :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

Hyundai Venue. Rear Door Module. Repair procedures
7.
Disconnect the various connector fron the rear door module and separate the rear door module wiring harness (A).
8.
Remove the rear door latch assembly.
(Refer to Rear Door - "Rear Door Latch Assembly")
9.
Remove the rear power window motor.
(Refer to Body Electrical System - "Power Window Motor")
10.
To install, reverse removal procedure.
Hyundai Venue. Rear Door Module. Repair procedures   
•
Make sure connectors are connected properly and each rod is connected securely.
•
Make sure the door locks / unlocks and opens / closes properly.

    Component Location 1. Rear door module

    Removal 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Cut the heat welds with a knife and remove the front door inside handle (A).

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Heater Unit. Components and components location

    Component Location 1. Heater unit assembly Compoents 1. Mode control actuator 2. Heater core case 3. Center duct seal 4. PTC heater 5. Heater core assembly 6. Heater case [LH] 7.

    Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures

    Variant Coding    When you need variant coding: – Replace Front View Camera with a new one ※ EOL Variant Coding and calibration required for new replacement Front View Camera Variant Coding

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0147