| Component Location |

| 1. Rear door outside handle |
Removal 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Cut the heat welds with a knife and remove the front door inside handle (A).
Replacement • When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.
Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.
Diagnosis with Diagnostic tool 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (Diagnostic tool). The diagnostic system (Diagnostic tool) provides the following information.