| Replacement |
|
| 1. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
|
| 2. |
Remove the plug hole (A).
|
| 3. |
By operating the power window switch, pull down until the glass mounting
bolt on plug hole is visible.
|
| 4. |
Remove the rear door inside weatherstrip (A).
|
| 5. |
Loosen the mounting screw and remove the rear door outside weatherstrip
(A).
|
| 6. |
Loosen the mounting screw, nut and remove the rear delta fixed glass
(A).
|
| 7. |
Loosen the mounting bolt and then pull out the rear door window glass
(A) by tilting it sideways.
|
| 8. |
To install, reverse removal procedure.
|
Component Location 1. Rear door window glass
Component Location 1. Rear door module
Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.
Replacement 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal.