Hyundai Venue (QX): Rear Seat / Rear Seat Cushion Cover. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Seat Cushion Cover. Repair procedures

Replacement
Hyundai Venue. Rear Seat Cushion Cover. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
After removing the hog-ring clips (A) inside the rear seat back cover, remove the seat cushion cover (B).
[Front]

Hyundai Venue. Rear Seat Cushion Cover. Repair procedures

[Rear]

Hyundai Venue. Rear Seat Cushion Cover. Repair procedures
3.
To install, reverse removal procedure.

    Component Location 1. Rear seat cushion cover

    Components Location 1. Reat seat latch

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Heater Unit. Components and components location

    Component Location 1. Heater unit assembly Compoents 1. Mode control actuator 2. Heater core case 3. Center duct seal 4. PTC heater 5. Heater core assembly 6. Heater case [LH] 7.

    Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Description and operation

    Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0183