| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the license lamp assembly after pushing the fixing clip (A).
|
| 3. |
Replace the bulb after turning the bulb socket (B) counterclockwise.
|
| Installation |
| 1. |
Install the bulb.
|
| 2. |
Install the license lamp lens.
|
Components Location 1. Compressor Components 1. Clutch bolt 2. Disc & Hub assembly 3. Clutch hub spacer 4. Snap ring 5. Pulley 6. Clutch magnetic coil 7.
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.