Hyundai Venue (QX): Fender / Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Fender / Repair procedures

Replacement
Hyundai Venue. Repair procedures   
•
When removing the fender, wrap protective tape around a screwdriver or remover not to damage components
•
Put on gloves to prevent hand injuries
Hyundai Venue. Repair procedures   
•
When removing the clips, use a clip remover.
1.
Remove the front bumper.
(Refer to Front Bumper - "Front Bumper Cover")
2.
Remove the head lamps.
(Refer to Body Electrical System - "Head Lamps")
3.
Remove the front wheel guard.
(Refer to Body Side Molding - "Front Wheel Guard")
4.
Using a remover and remove the fender garnish (A).

Hyundai Venue. Repair procedures
5.
Loosen the mounting screws and remove the front bumper side braket (A).

Hyundai Venue. Repair procedures
6.
Loosen the mounting bolts and remove the fender assembly (A).
Tightening torque :
6.9 - 8.8 N.m (0.7 - 0.9 kgf.m, 5.1 - 6.5 lb-ft)

Hyundai Venue. Repair procedures
7.
To install, reverse removal procedure.
Hyundai Venue. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Fender assembly

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Compressor. Repair procedures

    Removal    Precautions for using the plastic pulley • Be careful not to place the pulley to downwards of the floor or table.

    Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation

    Description Rear Corner Radar is a system that measures the relative speed and distance from the following vehicles by using two electromagnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0134