Hyundai Venue (QX): Body (Interior and Exterior) / Hood
- Repair procedures
- Hood Assembly. Components and components location
- Hood Assembly. Repair procedures
- Hood Insulator Pad. Repair procedures
- Hood Weatherstrip. Repair procedures
- Hood Latch Release Handle. Components and components location
- Hood Latch Release Handle. Repair procedures
- Hood Latch. Components and components location
- Hood Latch. Repair procedures
Replacement • When removing the fender, wrap protective tape around a screwdriver or remover not to damage components • Put on gloves to prevent hand injuries • When removing the clips, use a clip remover.
Adjustment 1. After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up and down or from side to side and tighten the bolt.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Components and components location
Component Location [Engine Room] 1. Condenser 2. Discharge hose 3. Suction & Liquid tube assembly 4. Compressor 5. Service port (High pressure) 6. A/C Pressure transducer (APT) 7. Service port (Low pressure) 8.
Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Child-Protector Rear Door Locks
- Rear Seat Assembly. Repair procedures
- Vehicle Information
- New on site
- Most important about car
