Hyundai Venue (QX): Body Side Molding / Roof Rack. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Body Side Molding / Roof Rack. Repair procedures

Removal
Hyundai Venue. Roof Rack. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Take care not to scratch the body surface.
1.
Using a flat-tip screwdriver and remove the roof rack cover (A).

Hyundai Venue. Roof Rack. Repair procedures
2.
Loosen the mounting nuts and remove the roof rack assembly (A).
Tightening torque :
3.9 - 4.4 N.m (0.4 - 0.45 kgf.m, 2.9 - 3.3 lb-ft)

Hyundai Venue. Roof Rack. Repair procedures
3.
To install, reverse removal procedure.
Hyundai Venue. Roof Rack. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Components Location 1. Roof rack cover 2. Roof rack assembly

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures

    Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.

    Hyundai Venue (QX) (2020-2026) Service Manual: Compressor oil. Repair procedures

    Oil Specification 1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor (PAG) oil varies according to compressor model.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0182